Rear Panel - Lorex L23WD800 Serie Manual Del Usuario

REAR PANEL

Connection Panel
1
Figure 1.2 System Connection panel (16-channel model shown).
1. BNC Video Input: Channel 1-16 camera inputs. BNC cameras require an extra power adapter.
(16-channel configuration shown. 8-channel configuration will have 8 BNC ports)
2. BNC Monitor Out: Composite output (top) to connect the system to a secondary monitor.
3. DIN Video Input: Channel 1-4 camera inputs for DIN cameras. DIN cameras draw power from the
system and do not require an additional power adapter.
NOTE: If you connect DIN cameras in channels 1~4, do not connect BNC cameras in channels 1~4. If two
cameras are plugged into the same channel, an overlap image appears.
Component Video In
4.
Video Inputs (Y/Pb/Pr).
Component Audio In
5.
Audio Inputs (Audio in Left/Right Channels). The Component Output must be turned ON on most DVD
Players before connection to the system.
6. LAN: Connect an Ethernet cable to connect the system to a router or switch (not included).
7. Alarm Block/ PTZ : Alarm inputs to connect external alarm or motion devices (not included).
• RELAY: The relay outputs one alarm signal.
• RS-485: PTZ (Pan, Tilt, Zoom) camera connection.
DVI Input
8. : Connect to a computer with DVI output. (DVI cable not included. Computer must have a DVI
output to use the system as a display.)
DC 12V
9. : Port for 12V power cable (included).
10. SPOT OUT: Spot video output (bottom) to connect to a secondary monitor. (Spot monitor only displays
cameras, not system menus).
11. RCA AUDIO INPUTS: Connect up to four audio inputs.
12. RCA AUDIO OUT: Connect a single audio output.
2 3
10
:Connect a DVD Player, Digital Cable or Satellite Receiver to the component
:Connect a DVD Player, Digital Cable or Satellite Receiver to the component
Hard Drive bay*
*For details on replacing the hard
drive, see "Appendix B: Replacing
the Hard Drive" on page 143.
4 5 6 7
11 12
Rear Panel
8 9
5