Appendix F: Connecting Ptz Cameras - Lorex L23WD800 Serie Manual Del Usuario

APPENDIX F: CONNECTING PTZ CAMERAS

You can connect RS-485 PTZ cameras (not included) to the PTZ Control Block on the rear panel of
the system.
DVR Rear Panel
D+ (TX+)/ D- (TX-)
*Note the orientation of the rear panel in the illustration, relative to the relay
diagram.
NOTE: The RS232 ports are for service use only.
To install a PTZ Camera:
1. Connect the Transmit Cable to the RS-485 D+ (TX+) port of the PTZ block on the rear panel.
2. Connect the Receive Cable to the RS-485 D- (TX-)port of the PTZ block on the rear panel.
3. Connect the video cable to a BNC port (usually channel 1).
4. Open the SYSTEM SETUP menu and select
5. Select PTZ SETUP and configure the ADDRESS, PROTOCOL, and BAUD RATE of your PTZ
camera.
NOTE: The PTZ camera settings depend on the type of PTZ camera. Please refer to the specific camera
manual for your brand and model of PTZ camera.
6. Click APPLY to save your settings.
NOTE: For details on controlling your PTZ camera, see "PTZ" on page 34.
Appendix F: Connecting PTZ Cameras
VIDEO (BNC)
PTZ CAMERA
(not included)
.
CAMERA
153