LORCH S Pulse XT Manual De Instrucciones página 58

Main level Level 1
Extras 3: Sprache/Language
4: Display contrast
5: Mode cooling system
6: Lock function
7:Throat thickness
8: Process Selection
9: Arc length control
- 58 -
Level 2
Display contrast
0 = Auto
1 = On
2 = Off
3 = 30 min
0
1
2
3
4.0 mm = 60 cm/min
01 TIG: on/off
02 Man.MIGMAG: on/off
03 Electrode: on/off
04 Standard: on/off
06 Synergic: on/off
07 SpeedArc: on/off
08 SpeedArcXT: on/off
09 Pulse: on/off
10 TwinPulse: on/off
11 SpeedPulse: on/off
12 S-TwinPulse: on/off
13 S-Pulse XT: on/off
14 S-TwinPulseXT: on/off
15 SpeedUp: on/off
16 SpeedRoot: on/off
17 SpeedCold: on/off
Voltage
Wire
909.2599.9-06
Secondary parameters
Note
Selection of menu languages
Contrast setting for the LCD display
Cooling system switches on as soon as the arc ignites
Cooling system runs continuously
Cooling system is switched off
Cooling system runs on for 30 minutes
all enabled
Welding current, mode, voltage/wire correction and Tip-
tronic On/Off released
Tiptronic On/Off, job selection enabled
All locked except menu selection, gas and pump test
Conversion between a dimension and welding speed.
Enter the desired a dimension (fillet weld thickness) in mm.
Using the set parameters wire diameter and wire feed
speed, the required welding speed is converted into cm/
min.
This function is very useful, e.g. for circular seam or longitu-
dinal seam automation tasks.
(Not available in "Man. MIGMAG" mode and for special
programmes)
By switching on or off, the available welding process is
added to or removed from the selection with the "Mode" S1
button.
the arc length is corrected using the rotary pulse encoder
S16
the wire feed speed is corrected using the rotary pulse
encoder S16
01.21