Removing The Bobbin; Winding The Bobbin - Texi Ballerina Manual De Operación

TEXI Ballerina manual operation
6. REINFORCEMENT BUTTON
Press Reinforcement button to sew 4 tie-off stitches at the same position and machine stop running.
7. NEEDLE DOWN button
Press the button and the needle stops in down position whenever you use the start/stop button.
8. Stitch length buttons
Press upper button for a longer stitch, press lower button for a shorter stitch. Is also used together with ME button
(displays quantity of patterns selected).
9. Stitch width buttons
Press upper button for a wider stitch, press lower button for a narrower stitch. Is also used together with ME button
(displays quantity of patterns selected).
10. Patterns: 200 kinds (displayed at the back of the manual)
Select patterns by pressing the pattern numbers (0-9) you selected. The pattern is displayed in the middle upper
part of the display.
BOBBIN WINDING

REMOVING THE BOBBIN

1. Remove the bobbin cover by sliding the release
lever to right and push down the left corner of
bobbin cover at the same time.
2. Remove the bobbin from the machine.

WINDING THE BOBBIN

1. Place a spool of thread onto the spool pin
and set the spool cap on it.
2. Pass thread through the thread guide.
3. Pass thread through the bobbin winder
thread guide.
4. Pass thread from spool through thread
guides as shown.
5. Insert thread through hole in bobbin from
inside-out.
6. Place the bobbin on bobbin winder spindle
and push to the right to engage bobbin
winder. Will appear on the LCD. When ready
for bobbin winding.
7. Hold the end of the thread and start
the machine.
8. After the bobbin winds a few turns, stop the machine and cut the thread near hole.
9. Start the machine again. Set the speed to maximum.
10. The bobbin winding will stop when bobbin is full. Stop the machine.
11. Remove the bobbin from the spindle and cut the thread.
133