Foot Controller; Control Panel Functions - Texi Ballerina Manual De Operación

TEXI Ballerina manual operation

FOOT CONTROLLER

Use of foot controller will permit control of start, stop and speed with your foot.
1. Turn off the power switch
2. Push foot controller plug into receptacle on machine.
3. Place foot controller at your feet and turn on power
switch. Sew faster by increasing the pressure on the
controller. To stop, remove your foot from the controller.
CONTROL BUTTON FUNCTIONS
The control button functions described in previous page will
change when the foot control is connected.
A. START/STOP BUTTON
This button will be deactivated.
B. SPEED CONTROL BUTTON
This button will limit the maximum speed.
C. REVERSE STITCH BUTTON
The machine will continue to sew reverse at same speed while this button is pressed.
When released, the machine will continue to sew forward.
WARNING: To reduce the risk of electric shock:
1. Handle the foot controller with care and avoid dropping it on the floor. Be sure not to place anything on its top.
2. Use only foot controller provided with this machine.

CONTROL PANEL FUNCTIONS

1. LCD display
Bottom left display the stitch size, middle section display the number
of selected pattern. Bottom right display stitch width.
2. CLEAR delete button
When the memory function is in use and you find a fault or wish to delete
a pattern from the memory, please use the buttons by fig.9 to look through
selected patterns. Press the CL button to erease the pattern shown in LCD
display. The memory function automaticly displays the next pattern.
3. ME starts memory function
Press the ME button, a light indicates that you can start the memory function.
Key-in the pattern numbers to the memory, a maximum of 60 patterns can be
stored in the memory (can not memory BH & button pattern). The machine will sew the patterns in the order they
have been keyed in. LCD display shows the selected pattern (001-200) being sewn.
4. RE starts repeat function
Press RE button, a light indicates that you can start the repeat function. When using the memory function and you
want to repeat sewing the same selection of patterns, press RE button, then press start, sewing machine will
continuously repeat patterns selected, until the stop button is presssed. To cancel press RE button.
5. MIRROR button
Press MI to mirror the stitch selected.
stitch: become become
132
SAFETY FEATURE
If the machine is jammed, it will stop with three
beep sounds. After the cause of jamming is
removed, step on the foot control and it will run
in normal condition.
become