Buttonhole Sewing; Multi-Stitch Zigzag - Texi Ballerina Manual De Operación

TEXI Ballerina manual operation

BUTTONHOLE SEWING

1. Mark position and length of buttonhole on fabric.
2. Set button on the base.
3. Pass upper thread through the hole of buttonhole foot and attach
the buttonhole foot to the machine.
4. Position fabric under presser foot so that the center line mark is in
the center of the needle opening in the buttonhole foot. With the remain
part of the foot pushed to the back lower the presser foot lever.
5. Lower the buttonhole foot lever so it is positioned behind the raised
finger on the foot.
6. Hold upper thread lightly and start the machine.
Note: Machine will not start to sew if buttonhole lever is not lowered
properly or buttonhole foot is not positioned correctly.
7. Machine will sew the buttonhole in the order shown and stop
automatically after sewing.
8. Raise the presser foot and cut thread. To sew over same buttonhole,
raise presser foot to return to original position.
9. Cut center of buttonhole being careful not to cut stitches on either
side. Use a pin as a stopper.
CAUTION: When using seam ripper, do not put your finger in the path
of ripper.

MULTI-STITCH ZIGZAG

Used for sewing on elastic band and overcast stitching on knit fabrics.
A. ELASTIC SEWING
Stretch elastic in front and back of needle while sewing. Be careful not to
bent needle while sewing.
B. OVERCAST STITCHING
Used for easy to ravel and knit fabrics. Guide fabric so stitch on right side
is at the edge on the fabric.
a = length of button + thickness
140