Miter Gauge Adjustment - Urrea SM1010 Manual De Usuario Y Garantía

the cabinet. This will keep the blade from tilt-
ing further.
• Turn the set screw (clockwise) until it comes
in contact with the positive stop.
• Check tilt indicator pointer. If necessary, a
just pointer so it points to 0° mark on scale. To
adjust pointer, remove hand wheel and loosen
screw on pointer. Be sure to tighten screw se-
curely after adjustment is completed.
Level adjusting screws
90° Stop Adjustment
45° STOP ADJUSTMENT
• Tilt the saw blade to 45°. Using a combina-
tion square, check to see if blade is 45° to the
table.
• If the blade will not tilt to 45°, turn (coun-
terclockwise) the set screw located at the right
of the table insert, until the blade can be posi-
tioned to 45°.
• With the blade at 45°, tighten the bevel hand
wheel lock knob to keep the blade from fur-
ther tilting.
• Turn the set screw clockwise until it comes in
contact with the positive stop.
TABLE INSERT ADJUSTMENT
• The table insert must always be level with the
saw table.
• Place a straight edge across the front and
rear of the table insert. Check that the insert is
perfectly level with the saw table.
• To level the table insert, turn one or more
adjusting set screws as needed and recheck.
• The table insert is equipped with two finger
holes for easy removal.

MITER GAUGE ADJUSTMENT

• Miter gauge supplied with saw is equipped
with individually adjustable index stops at 0°
and 45°, right and left, and can be manually
adjusted up to 60° right and left.
Adjustment to index stops can be made by
loosening locking nut and tightening or loos-
ening three adjusting screws.
45° Stop Adjustment
E N G L I S H •
Be sure to tighten locking nut after adjustment
is made.
• Face of miter gauge has two holes for pur-
pose of attaching auxiliary facing.
• Miter gauge is accurately constructed for pre-
cision work.
Miter gauge is guided through T-slot with a
roller guide mounted at front of guide bar.
Roller guide adds to miter gauge's stability and
prevents the guide bar from leaving T-slot.
• To operate miter gauge, simply loosen lock-
ing knob and move miter gauge to desired
angle. The miter gauge will stop at 0° and 45°,
both right and left. To position miter gauge
past these points, simply pull out gauge stop.
Position miter gauge at desired angle and
tighten locking knob.
• Be positive the edge of workpiece next
to face of miter gauge is straight and tight
against miter gauge so that the workpiece
does not rock or rotate. Always use both hands
when operating the miter gauge.
• The miter gauge is used for cross-cutting,
compound miter cutting, miter cutting, rab-
beting, bevel cutting and dadoing.
Index Stop Adjusting Screws and nuts
Locking Knob
Gauge Stop
RIP FENCE ADJUSTMENT
The saw's rip fence is precision manufactured,
incorporating fine adjustments for accurate
cuts. The saw is built to allow the operator to
accurately adjust the rip fence without prob-
lems in a matter of seconds.
U se r's m a n ua l
Roller guide
Milter gauge
47