Urrea SM1010 Manual De Usuario Y Garantía página 38

ATTACH CORD WRAP HOOKS
Tools Required: 4mm Hex Wrench
Hardware Required: Two M6 x 16 socket pan
head bolts, two M6 flat washers and two M6
hex nuts (Hardware bag #4).
• Insert a bolt into a cord wrap hook and place
against the holes on the left side of the saw
cabinet.
• Secure hook in position using flat washer and
hex nut.
• Repeat for other hook.
ATTACH BASE TO CABINET
Tools Required: 8mm Hex Wrench
Hardware Required: Four M10 x 25 socket head
bolts, four M10 lock washers and four M10 flat
washers (Hardware bag #4).
• Place dust chute over the cabinet as shown.
Make sure the holes in the corners are aligned
with the slots in the dust chute.
38
• Place the base assembly over the dust chute
and secure the base assembly to the cabinet
using the flat washers, lock washers and bolts.
• Secure all fasteners in the base assembly fully
tight.
ATTACH RIP FENCE BRACKETS
Tools Required: 5mm Hex Wrench
Hardware Required: Two M6 x 16 socket head
bolts, two M6 flat washers and two M6 hex
nuts (Hardware bag #4).
• Install the rip fence storage brackets to the
right side panel of the base using two bolts,
flat washers and hex nuts.
BLADE GUARD AND PUSH STICK STORAGE
BRACKETS
Tools Required: screwdriver and 4mm hex
wrench Hardware Required: Four M3 x 10 pan
head screws, four M3 lock washers, four M3
flat washers, four M5 x 12 socket head bolts,
four M5 lock washers and four M5 flat washers
(Hardware bag #4).
• Install the push stick storage brackets to the
left side panel of the base using four screws,
lock washers and flat washers.
• Install the blade guard storage brackets
to the left side panel of the base using four
screws, lock washers and flat washers.
NOTE: Attach the slotted bracket to the front
side of the saw.
• Press the four rubber feet to the base legs.