Adjustment - Urrea SB1014 Manual De Usuario Y Garantía

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

threaded bar sits in the angle
slide and the pivot pin inserts
into the pivot hole (Fig. 8 and
Fig. 9).
6. Tighten the ratchet handle
onto the threaded bar (Fig. 9).
UNPACKING AND COMPONENTS INCLUDED
The fence is supplied partly assembled. Prior to
use, further assembly is required
When unpacking the fence the following compo-
nents are included for the initial assembly (Fig. 10)
Fence Assembly
1. Fence bar (x1)
2. Fence fixing bar nuts and washers (x2) (as pic-
tured)
3. Fence carrier (x1)
4. Fence (x1)
5. Fence lock knob (x1)
6. Nuts, bolts and washers (x2) (as pictured)
Fig. 10
3
1
2
2
FIXING THE FENCE BAR
Locate fence bar onto the
table (Fig. 11) and fix with
the two fence fixing bar nuts
and washers. With these nuts
and washers in place on the
other side of the table (Fig.
12) Secure the fixings (Fig.
13). but do not fully tighten
yet as they may need to be
adjusted later in the setup
process.
FITTING THE FENCE CARRIER
Locate the fence carrier on
to the fence rail (Fig. 14).
FITTING THE RIP FENCE
Now simply slide the rip
fence on to the fence carrier
16
Fig. 9
4
5
6
Fig.11
Fig.12
Fig.13
and tighten the holding fixtures. Screw in the lock
knob to secure the position of the fence on the rail
(Fig. 14). The fence can be
used in the upright position
as shown or the fence can be
attached to the carrier using
the other 'T' slot giving an-
other position.
FENCE ALIGNMENT 1
Align the fence assembly in or out until parallel
with the side of the blade by turning the adjust-
ment collars and the fence bolts accordingly. If the
fixing nuts have been tightened, these will need
slackening off before this adjustment can be made.
FENCE
BOLTS
FENCE BAR
FENCE ALIGNMENT 2
Check that the fence is 90º to the table using a suit-
able square.
If no adjustment is needed fully tighten the fence
bar nuts. If adjustment is required this is achieved
by raising or lowering either side of the fence rail
until the fence itself is 90º to the table.
Once set at 90º fully tighten the fence bar nuts.

ADJUSTMENT

SETTING TABLE SQUARE TO SAW BLADE
CAUTION: before carrying out any adjustments
or maintenance ensure that the machine is iso-
lated and disconnected from the electricity supply.
Fig. 14
FENCE
ADJUSTMENT
COLLAR
MOVEMENT
FENCE
ADJUSTMENT
FENCE BAR
Tabla de contenido
loading

Tabla de contenido