Urrea SM1010 Manual De Usuario Y Garantía página 43

Sierra de mesa contractor
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Bushing
Insert pin here
Insert Bolt here
Attach Pawl Assembly
Set Screws
Latches lock and unlock blade Guard and Pawis
to riving knife.
INSTALL MITER GAUGE
• The miter gauge comes pre assembled. Un-
Notch
Pin
Bolt
Latches
E N G L I S H •
pack the miter gauge and clean thoroughly. In-
sert into storage slots on right side of cabinet.
INSTALL PUSH STICK
• Insert the push stick into brackets on left side
of base.
INSTALL RIP FENCE
• Position rip fence assembly at end of saw. Be
certain locking lever is in UP unlocked position.
• Place rip fence assembly onto rails, position-
ing clamp over rear rail and then placing rip
fence onto front guide rail.
• Rip fence should now ride freely on rip fence
rails. Once rip fence is completely installed, it
should be parallel with the miter gauge and
perpendicular to the table. If not, refer to "Rip
Fence Adjustment" in the Operation section of
this manual.
U se r's m a n ua l
43
Tabla de contenido
loading

Tabla de contenido