Urrea SM1010 Manual De Usuario Y Garantía página 39

• With the aid of an assistant turn the saw up-
right.
WARNING: To avoid injury, Do Not at-
tempt to turn saw upright by yourself.
Rubber Feet
Slotted Bracket
Front Side of Saw
ATTACH EXTENSION TABLES
Tools Required: 8mm Hex Wrench and Straight
Edge Hardware Required: Six M10 x 25 socket
head bolts, six M10 lock washers and six M10
flat washers (Hardware bag #1).
• Assemble extension table to the table using
socket head bolts, lock washers and flat wash-
ers.
• Wipe surface clean.
• Hand tighten only. Do not tighten complete-
ly until tables are level. Use a straightedge to
level tables.
• Repeat above procedure for the other exten-
sion table.
• Use a straight edge to check level and flat-
ness between main and extension tables.
• After tables are adjusted level and flat, se-
cure the extension tables by tightening the
bolts completely.
Straight Edge
INSTALL BLADE
• Loosen knob on right side of cabinet.
• Remove blade and wrench. Replace knob.
• Raise blade assembly all the way up.
• Depress arbor lock and use wrench to loosen
flange nut.
Remove flange and nut from arbor.
Blade guard
Bracket
Push Stick
Bracket
E N G L I S H •
• Place blade on arbor. Make sure arrow on
blade and teeth point towards front of saw.
• Replace flange and nut on arbor and securely
snug blade in position.
Arbor lock
CHECK TABLE ALIGNMENT
• Saws are shipped from the factory with the
table adjusted so the miter gauge slots are par-
allel to the saw blade.
However, in order to obtain the best results
from the saw, it is suggested this adjustment
be checked before operating.
• A simple method of checking alignment is as
follows: Bolt or clamp a dowel rod or similar
object to miter gauge (a combination square
can be substituted). Pick out a tooth on front
of blade and set the dowel to it so it is just
touching.
Move same tooth to back of blade.
• Gauge this tooth with the dowel rod. If the
tooth is in the same position, relative to the
miter gauge slot, the table is parallel with the
blade. In short, the miter gauge slots must be
parallel with the blade. This means that when
measuring distance between blade and miter
gauge slot at the front and rear of the blade,
the distances will be equal
NOTE: Be sure to measure the distance or
make the test on the same tooth of the saw
blade in both front and rear positions.
U se r's m a n ua l
Flange
Nut
39