Urrea SM1010 Manual De Usuario Y Garantía página 41

Use Straight edge to align rail joint to blade
Check parallelism of rails to table with combi-
nation square. Check at several locations along
rail.
• Loosen and remove six socket pan head
screws and the back panel. This will allow easi-
er attachment of the rear rails.
• Install the rear rails in the same manner as
the front rails and align the rail joint to the
blade.
• Replace back panel of the cabinet.
E N G L I S H •
Insert M8 x 20 hex bolts through holes in brack-
et at each end of brace. Attach brace to the far
right end of the rails by sliding hex bolts into
the rail T-slots. Secure bolts in position with flat
washers, lock washers and nuts.
ATTACH SWITCH ASSEMBLY
Tools Required: 10mm Open end Wrench
Hardware Required: Two M6 x 16 hex head
bolts, two M6 flat washers, two M6 lock wash-
ers and two M6 hex nuts.
(Hardware bag #3).
• From above switch assembly bracket, insert
two bolts through bracket holes.
• Loosely attach flat washer, lock washer and
nut to bolts.
• Insert bolt heads into T-slot on bottom of left
front rail.
• Slide switch assembly 6" to 8" from left end
of rail.
• Fully tighten flat washers, lock washers and
hex nuts to secure switch assembly in place.
U se r's m a n ua l
41