Urrea SM1010 Manual De Usuario Y Garantía página 42

POSITION AND ADJUST RIVING KNIFE
• Riving knife is installed on the saw. Raise the
blade completely to access the riving knife.
• Loosen the locking knob and raise the riving
knife to its highest position. Riving knife has
three holes for three positions.
The highest position is for all through cuts. The
middle position is for rabbets and other non-
through cuts, (with guard and pawls removed).
The lowest position is for dado cuts.
Locking
Knob
Plate
• Make sure locking pin is aligned with riving
knife hole and secure in position by tightening
locking knob.
• Riving knife must be in line with blade. Make
sure riving knife sits flat against mounting
bracket and lock plate.
RIVING KNIFE TO BLADE ADJUSTMENT
• Riving knife to blade clearance: the gap
between the riving knife and the saw blade
should be an even distance across the entire
radius.
• The riving knife should also be in line with
the saw blade. If adjustment is necessary:
1. Locate the riving knife bracket.
2. Loosen the two socket head cap screws
slightly enough to move the bracket, bring-
ing the riving knife in line with the saw blade.
Make sure the gap between the blade and
knife is even and from 1⁄4" to 5⁄16" in distance.
3. Once the riving knife is aligned with the
blade, tighten the socket head cap screws.
INSTALL TABLE INSERT
• Make sure that the riving knife is raised to its
highest position.
• Place table insert into throat of table.
• Insert is held in position by magnet in table.
42
Locking Pin
Screw
Bracket
• To adjust insert level with table, adjust level-
ing screws up or down.
Leveling Screwa
ATTACH BLADE GUARD AND
ANTI-KICKBACK PAWLS
• Place the slot of blade guard body over the
riving knife.
Slot of bushing is placed
• The bushings have a bevelled edge and must
be located in the center of the notch to lock
properly.
• Position guard completely down on riving
knife and press latch to lock in position.
• Blade guard body should be parallel to the
table. If not, adjust the 2mm set screws as nec-
essary.
• Place anti-kickback pawl set onto riving knife
at notches indicated. The spring pin is placed
in the front notch and bolt is placed in the rear
notch.
• Press pawl set completely down and press
latch to secure in position.
NOTE: The teeth of anti-kickback pawls should
touch table surface. Use set screws to adjust if
needed.
Blade Guard
Blade Guard and Pawl attachment
Pawl Set
Riving Knife