Immergas EOLO Star Manual De Instrucciones página 271

Separator kit Ø 80/80. The separator kit Ø 80/80, enables separation of the
fume exhaust and air intake pipes according to the diagram shown in the figure.
Fumes are expelled from pipe (B). Combustion air is drawn through pipe
(A). Intake pipe (A) can be installed either on the right or left side of the
middle exhaust pipe (B). Both pipes can be turned in any direction.
9
5
B
B
7
4
1
The kit comprises:
1 - Exhaust seal (1)
1 - Female intake flange (3)
1 - Flange seal (2)
1 - Female exhaust flange
2 - 90° bends Ø 80 (5)
• Assembly of separator kit Ø 80/80. Install flange (4) on the middle hole
of the boiler, interposing the seal (1) supplied and secure with the screws
supplied with the kit. Remove the flat flange on the side hole (accord-
ing to requirements) and replace it with flange (3), interposing seal (2)
already fitted on the boiler and secure with the screws supplied. Fit the
male end (smooth) of the bends (5) in the female end of the flanges (3
and 4). Fit the male end (smooth) of the intake terminal (6) up to the
stop on the female end of the bend (5), making sure to have already
inserted the relevant inside and outside rings. Fit the male end (smooth)
of the exhaust pipe (9) up to the stop on the female end of the bend (5),
making sure to have already inserted the relevant inside ring; this will
ensure correct hold and joining of the elements making up the kit.
• Coupling of extension pipes and elbows. To install snap-fit extensions
with other elements of the fume exhaust system, proceed as follows: fit
the male end (smooth) of the pipe or elbow up to the stop on the female
end (with lip seals) of the previously installed element; this will ensure
correct hold and joining of the elements.
• The following figure shows the configuration with vertical exhaust and
horizontal intake.
C82
5
6
7
8
A
A
3
2
1 - Intake terminal
Ø 80 (6)
2 - Inside rings (7)
1 - Outside ring (8)
1 - Exhaust pipe Ø 80 (9)
C52
ES
PT
GR
PL
TR
CZ
CS
SI
HU
RU
RO
IE
269