Factory Settings Folder - Ingersoll Rand R30 Información Del Producto

93014.15.06
Pages 3 and 4 – Digital Inputs
Digital Inputs:
Each digital input will have an indication showing whether the input is in
an "OPEN" or "CLOSED" state. This is the physical state of the input and may
not necessarily line up with the logical condition. The normal state is shown
below.
• Emergency Stop – Normally Closed
• Main/Fan Motor Overload – Normally Closed
• Remote Load Enable – Normally Open
• Remote Load/Unload – Normally Open
• Remote Start - Normally Open
• Remote Stop – Normally Closed
• Dryer Temperature Fault – Normally Open
• Dryer High Pressure – Normally Closed
Pages 5 & 6 – Digital Outputs
Digital Outputs:
Each digital output will have an indication showing whether the output is in
an "OPEN" or "CLOSED" state. This is the physical state of the input and may
not necessarily line up with the logical condition. The normal state is shown
below.
• Starter Contact KM1, KM2 – Normally Open
• Starter Contact KM3 – Normally Open
• Fan Starter Contact KM4 – Normally Open
80447162 Rev B
Figure 90 : Digital inputs
Figure 91 : Digital inputs
• Load Solenoid 1SV – Normally Open
• Modulation Solenoid 3SV – Normally Open
• Dryer Run / Fan Run – Normally Open
• PORO Horn – Normally Open
• Trip Indication – Normally Open
Page 7 – Analog Outputs
Figure 92 : Analog inputs
Analog Outputs:
The value for the analog outputs will be in mA.
• VSD Blower Output – Current speed of the VSD blower (if installed).
Page 8 – CT Inputs
Figure 93 : CT Inputs
CT Inputs
Displays the mA value of the current transformers installed on each leg of the
motor incoming power • CT1
• CT2
• CT3


Factory Settings folder

This folder is for Ingersoll Rand factory and service personnel. A password
must be entered on page one in order to adjust values in this folder. This
folder is used for setting parameters that are specifi c to that compressor and
displaying software information for the controller.
Page 1 – Password
Figure 84 : Password
Password:
Provides access to enter a valid password to gain access to password
protected parameters. The password is entered by scrolling down to the
password value and pressing the return key.
EN
EN-43