Attaching The Machine-Side Connector; Connecting The Coolant - Abicor Binzel ABIPLAS WELD 100 POWDER W Instructivo De Servicio

®
ABIPLAS WELD 100/150 POWDER W

6.2 Attaching the machine-side connector

6.3 Connecting the coolant

1 Join the central connector and socket at the power source and secure them
with the connection nut.
2 Connect the pilot power cable, control lead cable and powder hose to the
power source and the powder delivery unit.
WARNING
Risk of burns
If the coolant level is too low, the plasma powder welding torches will
overheat.
• Wear protective gloves.
• Regularly check the coolant level.
NOTICE
• Ensure that the coolant supply and return hoses have been installed
properly. Coolant supply = blue, coolant return = red.
• Do not use deionised or demineralised water as coolant or for leak and
flow tests. This may shorten your welding torch's service life.
• For liquid-cooled welding torches, we recommend using
ABICOR BINZEL BTC coolant.
1
4
1
Coolant return hose
2
Coolant supply hose
Fig. 4 Connecting the coolant
Bleed the entire cooling system as follows when used for the first time and after
every cable assembly replacement:
6 Putting into operation
2
3
Coolant recirculator
4
Control lead
3
EN - 15