Operation
Operation
Step 1: Filling the thermal module
The water tank of the thermal module must be filled with water before each operation.
§
Switch off the appliance by turning the on/off rotary switch with thermostat to the left.
§
Pull out the mains plug.
§
Fill the water tank with 25 oz (700 ml) cold water.
INFO
Step 2: Setting the temperature
The on/off rotary switch with thermostat, the red button of the safety temperature limiter, the control lamp and
the connecting lead are arranged on the panel of the thermal module.
§
Ensure that the appliance is switched off.
§
Connect the banquet trolley to the mains.
§
Set the required temperature using the on/off rotary switch with thermostat by turning the rotary
switch to the right.
WARNING
INFO
Step 3: Loading
After the operating temperature has been reached, the banquet trolley can be loaded with hot food in the
Gastronorm containers or meals already portioned on the grids.
WARNING
CAUTION
91101983_A4
Water supply
The amount of water in the thermal module is sufficient to supply the banquet
trolley with moist hot air for approx. 3.5 operating hours.
Hazard caused by hot surfaces
If the thermostat is set to position 3 and higher, the permitted maximum tem-
perature of 149°F (65°C) for touchable appliance surfaces can be exceeded.
This can cause burns.
The appliance set to the level 4 may only be operated by an instructed staff.
Wear suitable protective clothing.
Operating temperature
A temperature of approx. 203°F (95°C) is recommended for a normal opera-
tion. If the interior of the banquet trolley is empty, the operating temperature
will be reached in approx. 25 minutes.
Danger of escaping steam
Hot steam can escape when opening the door. Risk of burning.
Please stay at a safe distance and wait until the steam has volatilised.
Damage to the connecting lead
If the holder on the side of models BKW1/36 or BKW1/28 is used for hanging
the connecting lead, the latter may get damaged when the appliance is
moved.
Due to the width of the design of these models, the connecting lead would no
longer be protected by the bumper strips in this case.
Always reel up the connecting lead on the holders provided at the thermal
module before moving the appliance.
BKW1/14 L-GN | BKW1/20 L-GN | BKW1/36 B-GN | BKW1/14 L-GN+5PK | BKW1/28 B-GN+10PK | BKW1/23 L-GN
Section 5
Page 23
Banquet trolley heated | neutral