Preparing For Operation - ProTeam SIERRA El Manual Del Propietario

PREPARING FOR OPERATION

1. Unlatch and remove the top cap and pull out the Micro Cloth
filter. Check to see that the dome filter has not shifted during
shipping (Figure J). Reinstall the Micro Cloth filter, making sure
that the lip of the filter completely covers the rim of the vacuum
(Figure K).
2. Install an Intercept Micro Filter (if there is not one already
installed) by sliding the gasket of the Micro Filter over the inlet
on the inside of the top cap (Figure L). At the beginning of each
shift, the filters should be checked. Empty or replace as necessary.
NOTE: Never use an Intercept Micro Filter without the Micro
Cloth filter. (The Micro Cloth filter's rubber gasket provides
the seal.)
3. Replace the cap, making sure that the latches catch correctly.
Push the hose into the cap opening.
4. Twist the aluminum wand into the hose (Figure M). Check hose
cuffs at both ends to make sure that they are tight.
5. Loosen the shoulder straps and waist belt. In an open area, lift
the vacuum by one shoulder strap and slide your free arm into
the other strap (Figure N).
6. Fasten the waist belt snugly and make sure the weight is resting
comfortably on your hips (Figure O).
7. Thread the extension cord through the Cord Holder on the waist
belt (Figure O). DO NOT tie extension cord and power cord
together. Doing so will result in damage to both cords and will
not be covered under warranty (Figure P).
Residential Cleaning Manual
I n t r o d u c t I o n I N T R O D U C T I O N
Figure O Figure P
Figure J
Figure K
Figure L
Figure M
Figure N
7