Preparing The Vacuum For Operation - ProTeam GoCartVac Manual Del Propietário

PREPARING THE VACUUM FOR
OPERATION (Battery Power)
1. Lift the cover off the cart (Figure A).
2. Set cover in tray of cart (Figure B).
3. Unscrew the cap on the top of the vacuum unit (Figure C).
4. Check to make sure the filters have not shifted during shipping (Figure D).
Figure A
5. Replace filters and cap.
6. Replace cover plate and snap into position (Figure E).
7. Insert hose securely into the twist cap of the vacuum
through the cover plate (Figure F).
8. Plug the hose cord into the receptacle on the cover of cart (Figure G).
9. Attach wand to handle (Figure H) and accessory to end of wand.
Figure E
10. The operation of the vacuum is controlled by the switch
located on the gas pump handle of the hose. This is an
on/off switch and must be turned on in order for the vac-
uum to run. To maximize battery power remember to turn
the vacuum off when not in operation (Figure I).
IF THE VACUUM DOES NOT OPERATE, PROCEED TO
"CHARGING BATTERY INSTRUCTIONS" ON PAGE 8
7
Figure B
Figure F
Figure C
Figure G
Figure D
Figure H
Figure I
ProTeam