Vacuum Operation (Battery Power And Cord Power) - ProTeam GoCartVac Manual Del Usuario

VACUUM OPERATION
(Battery Power and Cord Power)
CHECK FILTER BEFORE OPERATION:
1. Lift the cover off the cart (Figure A).
2. Set cover in tray of cart (Figure B).
3. Unscrew the cap on the top of the vacuum unit (Figure C).
4. Check to make sure the filters are in place (Figure D).
Figure A
5. Replace filters and cap.
6. Replace cover plate and snap into position (Figure E).
7. Insert hose securely into the twist cap of the vacuum
through the cover plate (Figure F).
8. Plug the hose cord into the receptacle on the cover of cart (Figure G).
9. Attach wand to handle (Figure H) and accessory to end of wand.
Figure E
VACUUM OPERATION:
The plug port on the rear of the cart is for battery charging and for direct supply of
120V power to the vacuum. Turn adjacent rear-panel switch OFF (0) prior to con-
necting or removing extension cord.
1. The vacuum will operate directly from supplied cord power when the cord is con-
nected, rear-panel switch is ON, and pump handle switch is ON.
2. The vacuum will operate from battery power when the rear-panel switch is OFF.
Turn vacuum ON/OFF with the pump handle switch. (Disconnect cord).
IF THE VACUUM DOES NOT OPERATE, PROCEED TO
"CHARGING THE BATTERIES" ON PAGE 8.
ProTeam
Figure B
Figure F
Figure C
Figure G
Figure D
Figure H
7