SHERCO 125 4T Manual De Propietario página 48

By holding the button depressed for about 3 seconds while the unit of mea-
surement is selected (shown flashing with f=1Hz, Duty=50%), it is possible
to modify the number of wheel impulses. This parameter expresses the
number of impulses the electronic sensor sends to the instrument for each
complete turn of the wheel. The adjustment interval permitted ranges from
a minimum of 1 for each complete turn of the wheel to a maximum of 6.
Note 3 The impulses may also NOT have equal lapses of time between
them.
By holding the button depressed for about 3 seconds while the value is
selected, it is possible to return to standard operating mode
Fig.11 Adjustment of impulses for each complete turn of the wheel
Note 4 The information concerning the values for the wheel circumfe-
rence, unit of measurement and number of impulses for each turn of the
wheel selected, are saved to memory.
Note 5 Once into the adjustment menu, the system will return to normal
operation mode if 20 seconds pass without the button being pressed.
Note 6 Once into the adjustment menu, if the bike starts to move(speed>0),
the system will automatically return to normal operation mode.
22.8 Succession of functions shown
Scrolling through the functions is always possible, whether statio-
nary or moving, by pressing on the button in accordance with the
sequence shown below
TIME LAP TOD TD COUNTDOWN
48