Tabla de contenido
Enlaces rápidos
Tabla de contenido
Manuales relacionados para SHERCO ST Serie
Resumen de contenidos para SHERCO ST Serie
- Página 1 ST SERIES Manual de propietario / Manuel du propriétaire / Owner’s manual...
- Página 2 Sherco ST Series...
-
Página 3: Tabla De Contenido
Mantenimiento silenciador / Maintenance du silencieux / Muffler maintenance..........................19 Especificaciones técnicas / Specifications techniques / Technical specifications.........................20-21 Plan de mantenimiento / Plan d’entretien / Maintenance schedule............................22-23-24 Par de apriete / Couples de serrage / Tightening torques.................…..............………25 Productos recomendados / Produits recommandés / Recommended products..........................26 Sherco ST Series... -
Página 4: Introducción / Introduction / Introduction
Ce manuel ayant seulement un but informatif. Sherco is thankful for the confidence that you have given to us and we want to congratulate you on the purchase of a new Sherco for the practice of trials. This manual is intended to provide you with the basic information needed to perform the proper maintenance on your new bike, so that you can fully enjoy all its many features and qualities. -
Página 5: Número Bastidor / Num Châssis / Chassis No
Num bastidor / Num chassis / Chassis No. Todas las Sherco ST salen de fábrica con un único número de identificación, el cual se ha grabado previamente en el bastidor Distribuidor / Concessionaire / Dealer y es el que figura en la ficha técnica de la documentación que se entrega al usuario final. Este número no se puede reemplaza r ni modificar bajo ningún concepto. -
Página 6: Cadena / Chaîne / Chain
4 cms. The chain must be the object of special attention since the life of the sprockets and the chain are dependent on good maintenance. It is recommended that it be cleaned and lubricated frequently. Use special chain lube on the chain. Sherco ST Series... -
Página 7: Tensor Cadena / Tendeur De Chaîne / Chain Tensioner
0.27 and 0.30 bar (4 and 4.5 psi). For long trips, it is recommended to use the highest possible recommend ed pressure on the chain. It is important to keep it clean and well pressure. oiled. Sherco ST Series... -
Página 8: Puño De Gas / Poignée D'accélération / Throttle Assembly
Sherco ST Series... -
Página 9: Control Líquido Embrague / Contrôle Du Liquide D'embrayage / Clutch Liquid Control
Use motorcycle completely disengages, and before that the lever special mineral oil Minerva. is in contact with the other fingers. Tighten the counter nut nº2. Sherco ST Series... -
Página 10: Ajuste Pedal Freno / Ajustage De La Pédale De Frein / Brake Pedal Adjustment
Gear changing is more sporadic while the operation of the brake is more continuous, it is very important to keep the tips and the for free play. associated springs and pivot points clean and well lubricated so that the tips maintain a full 90 degree operating range. Sherco ST Series... -
Página 11: Ajustes Líquido Frenos / Ajustage Du Liquide De Frein / Brake Liquid Adjustment
The purge valve has a black protective cove r and right next to the throttle assembly. is located next to the hose attachment point. Sherco ST Series... -
Página 12: Depósito Liquido Freno Trasero / Réservoir Du Liquide De Frein Arrière / Back Brake Liquid Reservoir
The reservoir is easy to see from the left side of the the pads when they are less than 2mm thick, so as to obtain the best braking performance. Pay close attention to the rear pad s motorbike, right behind the carburetor. since they are normally more worn-out. Sherco ST Series... -
Página 13: Ajustes Suspensiones / Ajustage Des Suspensions / Suspensions Adjustment
Note that this bolt also This adjustment establishes the stiffness of the suspension. right fork leg. This adjustment determines how fast the anchors the fork internal components. Filling is accomplished suspension will compress and then rebound. by removing the top cap. Sherco ST Series... -
Página 14: Control Guardapolvo Suspensión / Contrôle Des Garde-Boue De Suspension / Suspension Mudguards Control
The performance of any operation will not affect the shock absorber travel. The factory settings are based on a rider’s weight of 70 -80 kgs. Sherco ST Series... -
Página 15: Cambio Aceite Motor / Changement De L'huile Du Moteur / Engines Oil Change
Remove the filling plug which is located just behind the water pump. Fill the crankcase with 7 00 cc kept in perfect condition and the gap should be set per the of 10W40 motor oil. To facilitate this operation slightly tilt the bike . manufacturers specifications. Sherco ST Series... -
Página 16: Control De Muelles Estriberas / Contrôle Du Ressort De Repose Pied / Footpeg Spring Control
The smooth functioning of the rear suspension depends, to a lever. This placement is important for the proper operation of great extent, on the proper funcioning of this section. the lever. Sherco ST Series... -
Página 17: Control Filtro Aire / Contrôle Du Filtre D'air / Air Filter Control
Keihin). The jetting has been set at the factory; filter oil. properly placed, it can cause a poor supply of petrol to the however minor adjustments may be required depending on the carburetor. altitude and climatic conditions. Sherco ST Series... -
Página 18: Posición Manillar / Position Du Guidon / Handlebar Position
Sherco ST Series... -
Página 19: Botón De Paro Motor / Bouton D'arrêt Du Moteur / Button To Stop The Engine
A rubber block eases their coupling, so neither the attached only by three screws. It allows the handling and interrupted, the stopping cycle becomes a lot smoother. swingers nor the kickstand are damaged. change of muffler fibers. Sherco ST Series... -
Página 20: Especificaciones Técnicas / Specifications Techniques / Technical Specifications
Oil type Amortiguador - Suspensión trasera Amortisseur - Suspension arrière Absorber travel - Rear Suspension Pre carga del muelle Pré charge du ressort Shock preload … … … … … … … … … … … … Sherco ST Series... - Página 21 Sae 5 … R16V 175 mm R16V 175 mm R16V 175 mm … 123.5 +-1 mm 123.5 +-1 mm 123.5 +-1 mm … … … … … … … … … … … … … … … … Sherco ST Series...
-
Página 22: Mantenimiento Anual
En uso de competición hay que revisar 20 horas después de cada carrera. Comprobar regularmente el apriete de todas las tuercas, No retrasar la revisión más de dos horas. tornillos, llaves ¡ Las revisiones en los talleres Sherco no sustituyen los controles y el mantenimiento del piloto ! Sherco ST Series... -
Página 23: Entretien Annuel
Il ne faut pas dépasser la révision de plus de 2 heures. Les révisions dans les ateliers Sherco ne remplacent pas les contrôles et l’entretien par le pilote ! Vérifier régulièrement le serrage des écrous, vis, colliers Sherco ST Series... -
Página 24: Maintenance Schedule
In competition you have to perform the 20 hour maintenance schedule after each race! Check tightness of nuts, screws and clamps This should not be exceeded by more than 2 hours. The services performed by the Sherco dealer do not replace routine service and maintenance by the rider! Sherco ST Series... -
Página 25: Par De Apriete / Couples De Serrage / Tightening Torques
Tuerca de columna de dirección Ecrous de colonne de direction Steering shaft nut 20Nm Tuerca de rueda delantera Ecrou axe de roue avant Front wheel nut 50Nm Tuerca de rueda trasera Ecrou axe de roue arrière Rear wheel nut 50Nm Sherco ST Series... -
Página 26: Productos Recomendados / Produits Recommandés / Recommended Products
Llave de bujías, destornillador Sherco recomienda lubricantes y productos de mantenimiento Minerva para el buen cuidado de la Sherco de trial. Solicita en tu concesionario Sherco los productos adecuados para cada necesidad, te ayudarán a obtener un mejor rendimiento y longevidad La Sherco est livrée avec un ensemble d’outils basiques... - Página 27 Sherco ST Series...
- Página 28 Sherco ST Series...