Battery Pack
Chemistry
Lithium-ion
Run Time:
Standard – TR-330
Approximately 4-6 hours*
High capacity – TR-332
Approximately 8 -12 hours*
* Estimated system run time based on testing with a new battery and a
new clean filter at 68°F (20°C). Actual system run time may be extended or
shortened depending on system configuration and environment.
Time to recharge:
< 3.0 hours
Standard – TR-330
< 3.5 hours
High capacity – TR-332
Internal charging temperature
Optimal: 60°F (20°C) to 95°F (35°C)
Range: 32°F (0°C) to 104°F (40°C)
NOTE: Consult a transportation specialist for any requirements or
limitations prior to transporting lithium ion battery packs.
Motor/blower Alarms:
Low air flow
Activates when airflow falls below 6 CFM (170 lpm) for greater than
approximately 30 seconds. If alarm condition continues (airflow remains
below 6 CFM) for approximately 15 minutes, the TR-300 system will
automatically shut down.
Low battery pack voltage
Activates when approximately 10-15 minutes of power remains. Power down
the motor/blower and replace the battery pack to reset alarm. This alarm
will also activate if the battery pack temperature reaches 130°F (55°C). See
Troubleshooting section of these User Instructions.
System Alarm
Audible alarms – 85 dBA at 4 inches (10 cm)
Intrinsic Safety
The TR-300 assembly is not an intrinsically safe system.
Latex
The TR-300 assembly does not contain dry or natural rubber latex
For additional specifications refer to the 3M™ Versaflo™ Powered Air Purifying Respirator TR-300 Technical
Specifications sheet.
Assigned Protection Factor
Refer to the User Instructions for the specific head gear to be used to determine the assigned protection factor
(APF) for the TR-300 PAPR system. Consult 3M Technical Data Bulletin #175 for additional information on APFs and
supporting test data.
HE Filter, Prefilter, Spark Arrestor Service Life
The HE filter must be changed if the low airflow alarm is activated, the air flow as shown by the air flow indicator falls
below 6 CFM or the HE filter becomes damaged or wet. The TR-3600 should be replaced when it is dirty or damaged
and whenever the HE filter is replaced. The TR-362 should be replaced whenever it is damaged.
An excessively loaded HE filter, prefilter or spark arrestor/prefilter may also reduce battery pack run time. If run time is
shorter than expected replacing the filters may resolve the problem.
TR-341N andTR-344N Battery Charger Display
Orange LED
Green LED
Battery Pack Charge Status
On – steady
Off
Quick charge mode
Less than 90% charge
On – steady
On - Slow Flash
Trickle charge mode
90% charge
Off
On – Steady
Fully charged
On – Quick Flash
On – Quick Flash
Error - See Trouble Shooting Section
On – Slow Flash
Off
Battery pack internal temperature too hot or cold
Slow flash – 1 flash per second; Quick flash – 2 per second
TABLE 1
12
LISTING OF COMPONENTS, ACCESSORIES AND REPLACEMENT PARTS
There are no user serviceable parts inside the TR-300 PAPR Assembly. The motor/blower unit should not be opened to
attempt repairs. Consult the 3M™ Versaflo™ Powered Air Purifying Respirator TR-300 Parts and Accessories guide for
additional information including a listing of 3M™ Versaflo™ TR-300 PAPR part numbers and exploded views.
Versaflo TR-300
PAPR Part #
Kits & Assemblies
TR-302N
PAPR Unit (includes blower unit, cover, and airflow indicator)
TR-304N
Versaflo™ PAPR Assembly with Easy Clean Belt and Economy Battery pack
TR-305N
Versaflo™ PAPR Assembly with Standard Belt, Economy Battery pack, and Battery Charger
TR-306N
Versaflo™ PAPR Assembly with High Durability Belt, High Capacity Battery pack, and
Battery Charger
TR-307N
Versaflo™ PAPR Assembly with Easy Clean Belt, High Capacity Battery pack, and Battery
Charger
Belts & Back Packs
TR-325
Standard Belt – Polyester Webbing, 62 inches long
TR-326
High Durability – Leather, 52 inches long
15-0099-06
Leather Belt Extender
TR-327
Easy Clean Belt –Polyurethane Coated Polyester, 62 inches long
BPK-01
Back Pack
Batteries & Charger Kits
TR-330
Economy Battery Pack
TR-332
High Capacity Battery Pack
TR-341N
Single Station Battery Charger Kit
Contains: TR-340 and TR-941N
TR-344N
4-Station Battery Charger Kit
Contains: 4 TR-340 and 1 TR-944N
TR-340
Battery Charger Cradle
Filters
TR-3712N-5
HE Filter (5 per case) - (NOTE: Replacement for TR-3710N filter)
TR-3712N-40
HE Filter (40 per case) - (NOTE: Replacement for TR-3710N filter)
Replacement Parts & Additional Accessories
TR-301N
Replacement Blower for TR-300 PAPR
TR-329
Suspenders
TR-3600
Prefilter – for use with selected 3M hoods and headtops.
TR-362
Spark Arrestor/Prefilter – for use with selected 3M headgear and Speedglas welding
headgear
TR-371
Filter Cover - (NOTE: Replacement for TR-370 filter cover)
TR-380
Filter Surround Gasket
TR-941N
Replacement Power Supply, Single Station
TR-944N
Replacement Power Supply and base, 4-Station
TR-970
Airflow Indicator
BT-922
Breathing Tube Cover
BT-926
High Temperature Breathing Tube Cover
Description
13