Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4
Procedure to install the automation and sliding doors
Installation of an automatic sliding door, carried out by professionally competent staff, can only take place following inspection on site (as indicated in chapter
1) and having sized and created the fixture and the automation.
Fastening to the wall of the box profile must be safe and adequate for the weight of the doors. Distribute the fastening points every 500÷800 mm, using ade-
quate plugs and screws, not supplied by us, based on the wall used for fastening. Perforate corresponding to the furrow prepared inside the box profile
N.B. The wall must be straight and smooth, otherwise you have to prepare adequate shims or plates in iron to fasten the box to, for correct levelling.
4.1 BOX ASSEMBLY
01AL0003
MAX 70mm
01AL0011
01FE0018
4.2 DOORS ADJUSTMENT AND ASSEMBLY
Fasten the sliding door to the carriages using the 8MA screws.
Close the doors and adjust the height and depth, as indicated in the figure.
Adjust the position of the upper stop castors to avoid the carriage exiting the sliding profile.
150
OPEN
99AC0001
99AC0002
99AC0003
A
01FE0049
C
A
C
OPEN
99AC0004
99AC0005
99AC0006
01FE0049
B
B
7
Capítulos
Tabla de contenido
