More Options - ResMed Lumis Serie Manual Del Usuario

If you continue to get a dry nose or mouth, or moisture in your mask, consider using ClimateLineAir
heated air tubing. ClimateLineAir together with Climate Control delivers more comfortable therapy.
Mask Fit
Mask Fit is designed to help you assess and identify possible air leaks around your mask.
To stop Mask Fit, press the dial or Start/Stop. If you are unable to get a good mask seal, assess
whether you have the right mask size and/or type or talk to your care provider.

More options

There are some more options on your device which you can personalise.
Mask
Run Warm Up
Ramp Down*
Leak Alert*
SmartStart*
*When enabled by your care provider.
8
To check Mask Fit:
1. Fit the mask as described in the mask user guide.
2. In My Options, turn the dial to highlight Run Mask Fit and then press the
dial.
The device starts blowing air.
3. Adjust the mask, mask cushion and headgear until you get a Good result.
This option shows your mask type setting. If you use more than one type of mask, adjust this
setting when switching between masks.
This option allows you to pre-heat the water before starting therapy, so that the air is not cold
or dry at the beginning of therapy.
This option is intended to make stopping therapy more comfortable by reducing your pressure
over a fixed 15 minute period.
When Leak Alert is enabled, the device beeps if the mask leaks too much air or if you remove
the mask during therapy.
When SmartStart is enabled, therapy starts automatically when you breathe into your mask.
When you remove your mask, it stops automatically after few seconds.
To adjust the Humidity Level:
1. In My Options, turn the dial to highlight Humidity
Level and then press the dial.
2. Turn the dial to adjust the humidity level and press
the dial to save the change.