WARNING
Always unplug the power supply cable from the
socket before moving the machine.
CAUTION
Never apply force to the wheel spin shaft when
moving the machine.
INSTALLATION
WARNING
Carry out the unpacking, assembly and installa-
tion operations indicated below with great care.
Failure to comply with these instructions could
damage the machine and put the operator at risk.
Remove the original packing materials after
positioning them as indicated on the packaging
and keep them intact so that the machine can be
safely shipped at a later date if necessary.
WARNING
The place where the machine is to be installed
must conform to applicable safety at work
regulations.
In particular, the machine must only be installed
and used in protected environments where
there is no risk of dripping onto it.
The floor must be strong enough to support
a load equal to the weight of the equipment
plus the maximum load allowed. The support
base on the floor and the envisaged fixing
means must also be taken into account.
IMPORTANT:
for the correct and safe operation of the machine,
the lighting level in the place of use should be
at least 300 lux.
Environmental operating conditions must comply
with the following requirements:
- relative humidity ranging from 30% to 80%
(without condensation);
- temperature ranging from 5° to +40°C.
44
CAUTION
For information concerning the technical fea-
tures, warnings and maintenance instructions
consult the related operator manuals provided
with the documentation of the machine.
WARNING
The machine must not be operated in potentially
explosive atmospheres.
The machine is supplied partially disassembled
and is to be assembled according to the proce-
dures described below.
LCD display head and relevant
support assembly instructions
- fix the display head support (A, fig.4) to the
weight tray and to the casing using the six screws
supplied with the machine (fig.4);
- insert the ground cable and the keypad cable
that exit the weight tray inside the previously
mounted support, as shown in figure 4a;
- fix the closing plate (A, fig.4b) using the eight
screws supplied with the machine;
- Unpack the LCD display head and fix it to the
support flange using the four screws supplied
with the machine (C, fig. 4c).
- connect the ground cable and the keypad cable
on the machine to the respective connectors
located on the rear side of the display head
(A,B, fig.4c);
EM 9550 - Operator's manual
4