Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

OP.2 PHASE
- Rotate the wheel until you reach the position
indicated by the illuminated central elements
of the position indicator.
- Mark the 12 o'clock position on the outer tyre
side using a piece of chalk.
- Press the
Press the
programme temporarily (the programme can
be accessed again by following the same
activation procedure described for the "OPT"
programme).
- Disassemble the wheel from the wheel balancer.
- Rotate the tyre on the rim until the chalk mark
is in line with the valve (180° rotation).
- Remount the wheel on the wheel balancer.
- Press the
formed rotation.
- Turn the wheel until the valve is in the 12 o'clock
position.
- Press the
- Perform a spin.
The improvement preview can be displayed
before continuing with the last phase of the
optimisation procedure. If the improvement is
considered insufficient or if no further signifi-
cant improvements can be achieved, press the
button to exit.
Proceed as follows to display the improvement
that can be achieved:
- press the
button once: the actual unbal-
ance values of the wheel as currently mounted
on the wheel balancer are now shown on the
displays;
- press the
button again: the unbalance
values indicated on the displays are the values
that can be achieved by continuing with the last
phase of the optimisation procedure;
- when the
third time, the machine prepares for the last
phase of the OPT programme.
66
button.
button to exit the "OPT"
button to confirm the per-
button.
button is pressed for the
OP.3 PHASE
- Rotate the wheel until you reach the position
indicated by the illuminated central elements
of the position indicator;
- Make a double mark on the outer side of the
tyre at the 12 o'clock position with a piece of
chalk. the screen indicates that the tyre should
be switched around on the rim, make a double
marking on the inner side with a piece of chalk.
The user can switch from the "with reversal" to
the "without reversal" mode by pressing the
key;
- Press the
button.
Press the
programme temporarily (the programme can
be accessed again by following the same ac-
tivation procedure described for the "OPT"
programme).
- Disassemble the wheel from the wheel balancer;
- Turn the tyre (and reverse its mounting if neces-
sary) on the rim until the double chalk mark is
in line with the valve;
- Remount the wheel on the wheel balancer;
- Press the
formed rotation;
- Perform a spin. When the spin is over the opti-
misation programme has been completed and
the weights to be applied to balance the wheel
are displayed.
If an error that may affect the end result occurs,
the machine indicates it by temporarily display-
ing the "E 6" message. The procedure can now
be repeated.

Special Cases

- The "OUT 2" message can be displayed at the
end of the first spin. In this case it is advisable
to exit the programme by pressing the key:
the values of the weights necessary
for balancing the wheel are displayed. The
execution of the programme is interrupted,
thus not achieving the moderate improvement
of the end results. By pressing the
the optimisation procedure can be continued.
EM 9550 - Operator's manual
button to exit the "OPT"
button to confirm the per-
key
Tabla de contenido
loading

Tabla de contenido