Cardin Elettronica SL Serie Manual Del Usuario página 77

• Press 'PROG/OK' again:
- the pause time count will start (minimum 2 seconds: maximum 240 seconds) indicated by 'PAUSE'
and the elapsed time appearing on the display.
• Press 'PROG/OK' again to set the pause time to the required time:
- 'OPENING' will appear on the display along with the indication 'AUTO PROG';
- the gate will now open slowly in order to find the completely open position;
- when the gate reaches the completely open travel limit it will invert the travel direction and after moving
a few centimetres it will open again to confirm the completely open position;
- 'CLOSING' will appear on the display along with the indication 'AUTO PROG';
- at this point the gate will start to close. When the gate reaches the completely closed travel limit it
will invert the travel direction and after moving a few centimetres it will close again to confirm the
completely closed position;
- after carrying out this manoeuvre the control logic will carry out a complete opening and closing cycle
at the standard operating speed in order to calibrate the current sensor;
- when the gate reaches the completely closed position the programmer saves the parameters and
quits the programming mode.
• If the operation has been successful the display will appear as follows.
• If the operation has not been successful 'PROGRAM' will remain flashing on the display and you will
have to repeat the programming procedure.
Start of the autoprogramming cycle
End of the autoprogramming cycle
77
PAUSE [30]
TB FI TA FD
FS CP TC TAL
AUTO PROG
00.000.007
07-06-16 15.35
OPENING
TB FI TA FD
FS CP TC TAL
AUTO PROG
00.000.007
07-06-16 15.35
CLOSING
TB FI TA FD
FS CP TC TAL
AUTO PROG
00.000.007
07-06-16 15.35
TB FI TA FD
FS CP TC TAL
00.000.007
07-06-16 15.35