Cardin Elettronica SL Serie Manual Del Usuario página 60

4o) Pause time
• Press PROG/OK to enter the sub menu.
• To adjust the pause time press the arrows until the desired time appears on the display:
- to reduce the time;
- to increase the time.
• If you hold the arrow down the value will scroll rapidly and the display will show the changes in real time.
• Press PROG/OK to confirm the chosen value.
• Press to move to the next parameter.
The pause time will be acquired during programming (see paragraph work time programming). This field will
allow you to change the pause time setting without repeating the entire work time programming procedure.
4p) Reset parameters
• To reset all parameters to their default values press the PROG/OK button.
• Press the key to confirm the choice and reset the parameters.
• Press the key to go back to the previous screen without changing the parameters.
• Press the key again to move to the next parameter.
Attention: This command will reset all the parameters to their default values including work times and current
sensor settings therefore you will have to repeat the gate programming procedure (see page 76).
4q) Firmware version
• The display shows the current firmware version eg. SLi924/V2.06
The firmware version varies according to the type of ECU (SL-BL-HL).
• Press the key to move to the next parameter
• Press PROG/OK to return to the main menu.
.
EXIT
60
4o) Pause time
DIST. FROM OPEN
5 STEPS
FINAL BRAKING
SETTING 1
PA U S E T I M E
240 SEC.
4p) Reset parameters
DIST. FROM OPEN
5 STEPS
PA U S E T I M E
240 SEC.
RESET PARAMETERS
OK
4q) Firmware version
RESET PARAMETERS
OK
FIRMWARE VERSION
SLi924/V2.06
EXIT