Right 45° Bevel Stop - Bosch 4212L Instrucciones De Funcionamiento Y Seguridad

Adjustments
Disconnect plug from power source
WARNING
!
before performing any assembly,
adjustment or repair to avoid possible injury.
Checking Right 45°
Bevel Stop
1. Lower head assembly and engage head assembly
lock pin.
2. Rotate table to the 0° miter position.
3. Pull up bevel lock lever to unlock bevel.
4. Move bevel range selector knob to "0°-45° Right" position. (See page 26)
5. Tilt the saw to the right until you feel the stop in the
45° right position. This is where the saw is cur-
rently set for the 45° right bevel cut.
6. Use a combination square to check blade at the
45° stop. Place the combination square head on
the table and press it's 45° surface against the
blade. If the blade does not contact the full length
of the square, (figure 1), follow the calibrating pro-
cedure.
Calibrating Right 45°
Bevel Stop
1. Lift bevel lock lever to release bevel lock.
2. Tilt saw to 45° right bevel position.
3. Position combination square with 45° surface
against blade. (Figure 1)
4. Insert 3 mm "L" wrench into Right 45° hole in ver-
tical support frame. (Figure 2)
5. Rotate "L" wrench while viewing blade against
combination square until it matches 45° surface.
6. Adjust bevel pointer to 45° line on bevel scale.
(continued)
Figure 1. Right 45° Bevel Stop
3mm "L"
Wrench
in
Right 45°
Access
Hole
Figure 2. Right 45° Bevel Adjustment
14.
Combination
Square
Bevel
Pointer