Portable Mounting Using Clamps; Adjusting The Four Position Switch Handle - Bosch 4212L Instrucciones De Funcionamiento Y Seguridad

Portable Mounting Using Clamps

If necessary, clamp the miter saw to a workbench or
table top by placing two (2) or more "C" clamps on
the clamping areas and secure.
NOTE: Be careful not to place clamps over the base
extension clamping levers.
Mounting with clamps will prevent access to some
wide miter angles.

Adjusting the Four Position Switch Handle

Handle
Lock
Clamp
Handle
Rotation
Release
Lever
a.
Setting Main Handle in
Desired Position
The switch handle can be positioned in any of four
different orientations, depending on the cutting
situation and user preference:
a. Vertical b. 45° Left c. Horizontal d. 45° Right
To reposition the main handle:
1. Release handle lock clamp.
2. Pull and hold handle rotation release lever
3. Rotate handle to desired location.
4. Let go over release lever to set handle into
place. Release lever will retract down only in
one of the four (4) positions.
Note: Power switch can not be actuated unless
release lever is retracted down. Do not attempt to
Mounting Applications
b.
c.
Figure: Setting Main Handle Position
19.
Clamps
Figure: Portable Mounting Using Clamps
switch tool on between handle position, damage may
occur.
5. Lock the handle clamp.
Adjusting the Four-Position
Handle Lock Clamp Tension
1. Open handle lock clamp.
2. Locate the two setscrews at the end of the handle
clamp.
3. To increase tension, use 1.5 mm Allen wrench and
rotate both setscrews to the right. To decrease ten-
sion, rotate both setscrews to the left.
Note: Always adjust both setscrews by the same
amount.
4. Close handle lock clamp.
5. Check the tension.
d.