Discharging Used Water; Interruption Of A Sterilization Cycle - Tecno-gaz alia B Instrucciones De Uso

8.9

Discharging used water

When the icon of used water turns on the tank has to be discharged, otherwise the
autoclave operation is inhibited. Fit the hose (FIG.16) into the water discharge plug on the
front panel of the autoclave (FIG.2–pos.13), at the same time put the other end of the hose
into a container; the water will drop into such container.
IMPORTANT:
A - The hose located in the receiving container, must never touch or be immersed in
the discharged water, otherwise sucking up will occur.
B – Always wait until the discharge water has been completely drained. The used water
maximum level LED turns off when some water still remains into the tank, consequently do
not considered it as a reference for this operation.
At the end of the discharge press the ring nut on the plug and remove the hose.
8.10

Interruption of a sterilization cycle

A sterilization cycle can be voluntarily interrupted by pressing the button
seconds. The autoclave will send out a beep, align with the atmospheric pressure and the
display will show the alarm message A001 (Interrupted cycle).
To reset the alarm hold down at the same time the buttons below the bar indicated with
Reset (FIG.27).
If an alarm message is displayed
considered as FAILED: all loading and sterilization operations have to be
repeated.
(suffix "A") the cycle has to be
FIG.27
ENGLISH
Stop for at least 2
27