Idiomas disponibles
Idiomas disponibles
Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and any
other condition that may affect its operation. A guard
or other part that is damaged should be properly
repaired or replaced by an authorized service center
unless indicated elsewhere in this manual.
Safety instructions for maintenance
WARNING:
continues to rotate even after the power
trigger has been released. If you have a
battery operated product, remove the battery
from the product. Make sure that the cutting
attachment has stopped completely before
you do maintenance on the attachment.
•
Make sure that the transport guard is attached
correctly to the cutting attachment when the product
is not in use, is transported or is in storage.
•
Always wear heavy-duty gloves when repairing
the cutting attachment. The cutting equipment is
extremely sharp and can easily cause cuts.
•
Store the product out of reach of children.
•
Use only original spare parts for repairs.
•
Never use a product that is faulty. Carry out the
safety checks, maintenance and service instructions
described in this manual. Some maintenance and
service measures must be carried out by trained and
qualified specialists.
•
Secure the machine during transport.
Safety instructions for the cutting
equipment
WARNING:
instructions that follow before you use the
product.
Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the guide bar and saw
chain
1. Unfold the tab on the locking knob (A) and turn the
locking knob counterclockwise. (Fig. 23)
2. Remove the cover (B).
3. Put the guide bar on the guide bar bolt. Make sure
that the chain adjustment pin (C) is in the correct
hole (D) in the guide bar. (Fig. 24)
4. Move the guide bar to its most rear position.
14
The cutting attachment
Read the warning
Assembly
Read and understand the
•
Only use approved guide bar/saw chain
combinations and filing equipment. Refer to
bar and saw chain combinations on page 19 for
instructions.
•
Use protective gloves when you use or do
maintenance on the saw chain. A saw chain that
does not move can also cause injuries.
•
Keep the cutting teeth correctly sharpened. Obey the
instructions and use the recommended file gauge. A
saw chain that is damaged or incorrectly sharpened
increases the risk of accidents.
(Fig. 19)
•
Keep the correct depth gauge setting. Obey the
instructions and use the recommended depth gauge
setting. Too large depth gauge setting increases the
risk of kickback.
(Fig. 20)
•
Make sure that the saw chain has the correct
tension. If the saw chain is not tight against the
guide bar, the saw chain can derail. An incorrect saw
chain tension increases wear on the guide bar, saw
chain and chain drive sprocket. Refer to
the chain tension on page 18 .
(Fig. 21)
•
Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
(Fig. 22)
5. Put the saw chain on the drive sprocket (E) and in
the groove on the guide bar. Start on the top side of
the guide bar.
6. Make sure that the edges of the cutting links point
forward on the top edge of the guide bar.
7. Make sure that the drive links of the saw chain are
correctly installed on the drive sprocket and that the
saw chain is in the groove in the guide bar.
8. Install the cover. Make sure that the flange (F) on the
cover is put correctly in the hole (G) on the cutting
head. (Fig. 25)
9. Turn the locking knob clockwise.
10. Turn the chain tensioning screw to add tension to
the saw chain. Use the screwdriver side of the
combination tool. (Fig. 26)
Guide
To adjust
2195 - 006 - 26.10.2023
