GE P2S975 Manual Del Propietário página 34

Before you call for service...
Troubleshooting tips
Save time and money/ Review the charts on the fofiowing
pages first and you may not need to carl for service,
Possible Causes What To Do
Burners have yellow or The combustion quality of
yellow-tipped flames burner flames needs to be
determined visually.
. Use the illustrations below to detet_nine if your burner
flames are non,hal. If burner flames look like ,4, ca/1 for
se_Mce. Normal burner flames should look like B or C,
depending on the type of gas you use. With LP gas, some
yellow tipping on oumr cones is normal
,4-Yellow flames B-Yeflow tips C-Sofl blue flames
Call for service on outer cones Normal for natural
Normalfor LPgas gas
Control knobs Knob isn't pushed down. . To turn from the OFF position, push the knob in and
will not turn
then turn.
Burnersdo notlight
Range Lock-Out feature is * Allow the nmge to cool down and touch and hold the
activated. RANGELOGK-OUT pad An 3 seconds undl the disp| W
shows LOCOFF.
Plug on range is not * Make sure elecuica/plug is plugged into a live, properly
completely inserted in the grounded outer.
electrical outlet.
Gas supply not connected • See the [nsm|ladon Instructions that came with your
or turned on. range.
A fuse in your home may be . Replace the fllse or reset the ci_vuit breaker
blown or the circuit breaker
tripped.
]Burner parts not replaced • See the Care
and cleaningof the range
secdon.
correctly.
Range Lock-Out feature * If LOg 0Nappears in the display, the range control is
is activated
locked. Turn this featme off to use the range. See the
Range Lock-Out section.
_cking sound ofspark
igniterpersistsafter
burnerlights
Control knob is still
in the LITE position.
* Turn the knob out of the LITE position to the desired
setting.
* Turn the burner off and relight. If ticking is still
present, call for service.
Burner flames very Improper air to gas ratio. * If range is connected to LP gas, check all steps
large oryellow
in the Installation Instructions that came with
your range.
Ovenlight does Light bulb is loose or defective. * Tighten or replace the bulb.
not work
Switch operating * Ca/1 fbr service.
light is broken.
Ovenwillnot work
Plug on range is not completely * Make sure electrical plug is plugged into a live, properly
inserted in the electrical outlet, gqounded outer.
A fuse in your home may
* Replace the fuse or reset the ci_vuit breaker
be blown or the circuit
breaker tripped.
34 Oven controls improperly set. * See the Using the oven section.