GE P2S975 Manual Del Propietário página 32

Careand cleaning oftherange.
Do not rub or clean the door gasket--
it has an extremely low resistance to
abrasion.
If you notice the gasket becoming worn,
frayed or damaged in any way or if it has
become displaced on the door, you should
have it replaced.
C/eaning the Oven Door
Todean the inside of the door:
iii}B
Because tlle area inside tlle gasket is
cleaned during the self:clean cycle, you
do not need to clean this by hand.
The area outside die gasket and
the door liner can be cleaned widl a
soal>filled or plastic scouring pad,
hot waWr and
dewrgent. Rinse well
with a vinegar and
water solution.
Toclean the outside of the door:
Use soap and water to dloroughly
clean the top, sides and fiont of the
oven doo_: Rinse well. You may a/so
use a glass cleaner to clean die glass
iiiB
iii}B
on the outside of die doo_: Do not let
water drip into die vent openings.
If any stain on the door vent tIiIn is
persistent, use a soft abrasive cleaner
and a sponge-scrubber fbr best results.
Spillage of marinades, fluitjuices,
tomato sauces and basting materials
containing acids may cause
discoloration and should be wiped
tap immediamly. When surface is cool,
clean and rinse.
}i_Do not use oven cleaners, cleaning
powders or ha_h abrasives on die
outside of the do(n:
Slot
Hinge lock
Pull hinge locks down to unlock.
Removal position
Lift-Off Oven Door
Thedooris very heavy.Be careful when
removingandliftingthe door.
Donot lift thedoorby thehandle.
Toremovethe door:
%
%
Fully open
the doo_:
Pull die hinge locks down toward
die door flame, to die unlocked
position. A tool, such as a small
flat-blade screwdrive,; may be
required.
Firmly grasp both sides of die door
at die top.
Close door to die door removal
position, which is ha/fi,vay between
die broil stop posidon and fully
closed.
[_ Lift door tap and ()tat undl die hinge
arm is clear of the slot.
Toreplacethe door:
[7] Firmly grasp both sides of die door
at die top.
Wkh die
Bottom Hinge arm
door at die edge
ofslot
same angle as X
die reIilOVa[
position, seat the
indentation of
the hinge arm
into the bottoul
edge of the hinge slot. The notch in
the hinge arm must be flail}, seated
into the bottom of the slot.
%
Fully open die dooI: If die door will
not fiflly open, die indentation is
not seared correc@ in the bottom
edge of the slot.
[_ Push die hinge locks tap against die
flont flame of the oven cavi b, to die
locked )osidon.
Hinge -_
arm
Hingelecl<_
_
Pushhingelocksup to lock,
[_] Close die oven door
32
PaintedSurfaces
Painted surfitces include the top and
sides of die doo,; top of die control panel
and the drawer fiont. Clean these with
soap and wamr or a vinegar and wamr
solution.
Do not use commercial oven cleaners,
cleaning powders, steel wool or harsh
abrasives on any painted suif_ce.