To Set The Depth Stop; Maintenance Schedule; Maintenance - Husqvarna TS 300 E Manual Del Usuario

1. Loosen the lock handle (A) of angle cutting.
A
2. Rotate the blade housing (B).
3. Tighten the lock handle to set 45° angle.

To set the depth stop

CAUTION:
blade is not rotating. Adjust the depth stop
when you change the cutting blade. Do a
check of the depth stop regularly or there
is a risk that the cutting slot and the water
system will not operate correctly.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.

Maintenance schedule

Maintenance

Do a check of the safety devices
of the product. Refer to
devices on the product on page
7 .
Clean the product externally. Re-
To clean the product exter-
fer to
nally on page 14 .
Do a check of the blade guard.
Refer to To do a check of the
blade guard on page 8 .
2282 - 002 - 07.02.2024
B
This must be done while the
Maintenance
Before you do any
Safety
Set the depth stop so the cutting blade gets maximum
depth without cutting into the conveyor cart.
1. Push down the cutting arm until the cutting blade hits
the bottom of the slot in the conveyor cart.
2. Hold down the cutting arm in this position.
3. Turn the depth stop screw to adjust the cutting depth
stop.
4. Tighten the locking nut.
5. Do a check of the position of the cutting blade by
moving the conveyor cart to its forward and rear end
position. Make sure that the cutting blade does not
hit the conveyor cart.
Daily
X
X
X
After usage
13