Carry Out The Following Periodic Checks On The Power Source; Responsibility; Alarm Codes - voestalpine bohler welding URANOS NX 2200 PMC Manual De Instrucciones

ALARM CODES

7.1 Carry out the following periodic checks on the power source

7.1.1 System
connections and all the connection cables.
7.1.2 For the maintenance or replacement of torch components, electrode holders and/or
EN
earth cables:
Check the temperature of the component and make sure that they are not overheated.
Always use gloves in compliance with the safety standards.
Use suitable wrenches and tools.

7.2 Responsibility

Failure to carry out the above maintenance will invalidate all warranties and exempt the manufacturer from any
liability. The manufacturer disclaims any responsibility if the user fails to follow these instructions. For any doubts
EN
IEC
and/or problems do not hesitate to contact your nearest customer service centre.
8. ALARM CODES
ALARM
Activation of an alarm or the passing of any critical limit causes a visual signal to appear on the control panel and
the immediate shut-down of welding operations.
CAUTION
Exceeding a guard limit causes a visual signal on the control panel but allows the welding operations to continue.
All the alarms and all the guard limits relating to the system are listed below.
Overtemperature
E01
Overcurrent
E05
Blocked motor
E08
Communication error WF1
E12.1
Invalid program
the error sub-code indicates the number
E14.xx
of the deleted job
Communication error RI
1000/2000/3000 (CAN bus)
E16.1
Communication error RI 1000/2000
E16.3
Overtemperature
E02
Wire feeder motor power supply fault
E07
Power module overcurrent (Inverter)
E10
Communication error (FP)
E13
Invalid program
E15
Communication error RI 3000 (Modbus)
E16.2
Communication error (μP-DSP)
E17
88