Guard Limits - voestalpine bohler welding URANOS NX 2200 PMC Manual De Instrucciones

SETUP
HI heat input measurement
768
Allows reading of the value of the measurement of the heat input in welding.
EN 1011-1

Guard limits

801
EN
parameters.
Allows the accurate control of the various welding phases.
Refer to section "Guard limits (Set up 801)".
5.1.3 List of set up parameters (MIG/MAG)
Save and Exit
0
Allows you to save the changes and exit the set up.
Reset
1
Allows you to reset all the parameters to the default values.
Welding programs
2
Standard MIG/MAG:
Allows selection of the manual MIG (
welded.
Pulsed MIG/MAG:
Allows selection of the synergic MIG (
Allows selection of the CC/CV ) process.
Refer to section "Front control panel".
Wire speed
3
Allows the regulation of the wire feed rate.
Minimum
0.5 m/min
Current
4
Allows the regulation of the welding current.
Minimum
3 A
Workpiece thickness
5
Allows the thickness of the part being welded to be set.
Corner bead "a"
6
Lets you set bead depth in a corner joint.
) or synergic MIG (
Maximum Default
22.0 m/min -
Maximum
Imax
78