voestalpine bohler welding URANOS NX 2200 PMC Manual De Instrucciones página 80

SETUP
500
Allows the selection of the required graphic interface.
Allows access to the higher set-up levels.
Refer to section "Interface personalisation (Set up 500)"
Value
USER
EN
SERV
vaBW
Lock/unlock
551
Allows the locking of the panel controls and the insertion of a protection code.
Refer to section "Lock/unlock (Set up 551)".
Buzzer tone
552
Permits adjustment of the buzzer tone.
Minimum
0/off
Regulation step
601
Allows the regulation of a parameter with a step that can be personalised by the operator.
Minimum
1
External parameter CH1, CH2, CH3, CH4
602
Allows the management of the external parameter 1, 2, 3, 4 (minimum value, maximum value, default value,
parameter selected).
Refer to section "External controls management (Set up 602)".
Circuit resistance calibration
705
Allows the calibration of the system.
Refer to section "Circuit resistance calibration (set up 705)".
Current reading
751
Allow the real value of the welding current to be displayed.
Voltage reading
752
Allows the real value of the welding voltage to be displayed.
HI heat input measurement
768
Allows reading of the value of the measurement of the heat input in welding.
EN 1011-1
Guard limits
801
parameters.
Allows the accurate control of the various welding phases.
Refer to section "Guard limits (Set up 801)".
5.1.2 List of set up parameters (TIG)
Save and Exit
0
Allows you to save the changes and exit the set up.
Reset
1
Allows you to reset all the parameters to the default values.
Selected level
User
Service
vaBW
Maximum Default
10 10
Maximum Default
Imax 1
Value User interface
XE Easy Mode
XA Advanced Mode
XP Professional Mode
76