Control Panel Functions; External Controls Management - voestalpine bohler welding URANOS NX 2200 PMC Manual De Instrucciones

5.2.3 Lock/unlock (Set up 551)
Allows the locking of the panel controls and the insertion of a protection code.
5.2.4 External controls management (Set up 602)
Allows the management of the external parameter 2 (minimum value, maximum value, default value, parameter selected).
Parameter selection
Select the required parameter (551).
Set a numerical code (password) by rotating the encoder.
Confirm the operation by pressing the encoder key.

Control panel functions

The carrying out of any operation on a locked control panel causes a
special screen to appear.
Access the panel functionalities temporarily (5 minutes) by rotating the encoder
and entering the correct password.
Confirm the operation by pressing the encoder key.
Unlock the control panel definitively by entering set-up (follow the instructions
given above) and bring back parameter 551 to "off".
Confirm the operation by pressing the encoder key.
Parameter selection
Select the required parameter (602).

External controls management

Select the required RC remote control output (CH1, CH2, CH3, CH4) by pressing
Select the required parameter (Min-Max-parameter) by pressing the encoder
Adjust the required parameter (Min-Max-parameter) by rotating the encoder.
85
.
.
.
.
.
SETUP
EN