Bu_on
Sewing
(_ Needle positions selector dial:
(_) Stitch length dial:
any
(_) Stitch width dial:
Set as illustrated
_) Needle thread tension:
2 to 6
®
Darning plate:
Attached (Page 36)
®
®
A pin can be placed on top of the foot to form a shank.
Set the Needle position selector at "_:3"°
Align both holes of the button with the slot of the foot and
place the left hole of the button just below the needle point..
Lower the foot and set the stitch width dial so that the needle
point comes just above the right hole of the button+
Sew about five stitches and raise the needle.
Set the stitch width dial at "0" and sew a few stitches to lock
the thread.
To strengthen the shank, cut the threads leaving a 8" (20 cm)
tai!.. Bring the needle thread down through the hole in the
button and wind it around the shank.
Draw the thread to the
wrong side and knot.
F
%.....
46
