Bobbin Winding
= Removing
bobbin
case
Remove the extension table from the machine by pulling it to
the leftoOpen the shuttle cover 0 by pulling down the
embossed part on the left of the cover,
Raise the needle to its highest position by rotating the
handwheel toward you_
(D Shuttle cover
_)
Bobbin case
To remove the bobbin case (_) from the shuttle, pull open the
latch of the bobbin case. Pull the bobbin case straight out of
the shuttle.
• Bobbin winding
[]
Release the clutch by pulling out the handwheel.
This
will stop the needle from moving while you wind the
bobbin_
[]
[]
Draw thread from spool°
[]
Guide the thread around the thread guide.
[]
Thread through the hole in the bobbin from the inside to
the outside.
[]
Put the bobbin on the bobbin winder spindle,
[]
[]
[]
16
