Threading the Machine
• Threading the machine
*
Raise the thread take-up lever to its highest position
by turning the handwheel counterclockwise,
toward
you.
*
Raise the presser foot lifter.
°
Place a spool on the spool pin, with thread coming
off as shown.
[]
Draw the end of thread around the upper thread guide..
[]
While holding the thread near the spool, draw the
end of the thread down around the check spring
holder+
[]
Firmly draw the thread up from right to left over
the take-up lever and down into the take-up lever
eye.
[]
Slide the thread behind the needle bar thread
guide on the left.
[]
Thread the needle from front to back or use a
needle threader.
• Drawing up bobbin thread
[]
Raise the presser fool Hold the needle thread
lightly with your left hand and rotate the handwheel
countemlockwise, toward you, for one complete turn,
[]
Bring the bobbin thread up by pulling the needle
thread up.
[]
Pull both threads under and to the back of the
presser foot, leaving 4 to 6 inches (10 cm to 15 cm)
of thread clear..
[]
[]
[]
22
