Setting A Station Over A Point With Coordinates - Hilti POS 15 Manual De Instrucciones

Continue with rotating the axis and shifting the axis as described in the applicable sections.

10.2.4 Setting a station over a point with coordinates

On many construction sites, measured points with coordinates already exist, or the positions of parts of the structure,
building control lines or foundations etc. are already described with coordinates.
In this case, the decision about whether coordinates or building control lines are to be used can be taken when the
station is being set up.
Setting up the tool over a point with coordinates
The tool is set up over a point marked on the floor or ground, the position of which is defined by coordinates and from
which the points or items to be measured are easily visible.
Special care must be taken to ensure that the tripod stands steadily and securely.
The tool is positioned at a point defined by coordinates P0 and, for the purpose of orientation, is aimed at another
point defined by coordinates P1.
The tool calculates the position within the coordinate system.
For better identification of the orientation point, the distance can be measured and compared with the coordinates.
NOTE
This makes correct identification of the orientation point more reliable. If the coordinate point P0 also has a height,
this will first be used as the station height. The height of the station can be redetermined and changed at any time
before the station is set finally.
The orientation point is decisive for correct calculation of direction and should therefore be selected and measured
with care.
10.2.4.1 Entering the position of the station
A designation that identifies the station or tool position clearly and uniquely must be entered. The coordinates of its
position must belong to this designation.
i.e. the station point may already exist as a saved point in the job or, alternatively, the coordinates will have to be
entered manually.
Cancel and return to previous
screen.
Confirm selection and continue
to station identification.
en
41