Hilti POS 15 Manual De Instrucciones página 60

Entering the layout points (from a CAD drawing)
The layout points are selected directly from a CAD drawing.
With this method, the point is already incorporated in the drawing as a three-dimensional or two-dimensional point
and can be extracted accordingly.
NOTE
If the option to exclude heights is activated when setting up the station, height values and all associated information
are not displayed. The other screens shown are the same as described in the previous section.
P0 is the position of the tool after setting up.
P1 is the point described by coordinates. After the tool has been lined up (aimed), the reflector bearer goes to the
approximate distance calculated.
Return to previous view.
Confirm entry and continue,
showing display for aligning the
tool with the point to be staked
or marked out.
Shows the point selected from
the graphical display.
Cancel and return to entry of
layout points.
Select a point from a plan.
Select a point from a list.
Enter coordinates manually.
Confirm the selected point.
en
55