Laying Out With Building Control Lines - Hilti POS 15 Manual De Instrucciones

The "Horizontal Layout" application is started by way of the corresponding button in the in the application menu.
After starting the application, the projects or list of projects (see section 13.2) is shown for selection as well as the
corresponding station selection or station setup.
The "Horizontal layout" application begins after station setup is completed.
Depending on the station selected, there are two alternative methods for determining the point to be laid out:
1. Laying out points using building control lines
2. Laying out points using coordinates and/or points based on a CAD drawing

11.1.2 Laying out with building control lines

When laying out with control lines, the layout values to be entered always refer to the building control line that has
been selected as the reference axis.
Entering layout points relative to the building control line
Enter the layout point as a dimension relative to the building control line defined when the station was set or,
respectively, the building control line on which the tool is set up.
The values to be entered are line and offset distances relative to the previously defined building control line.
Return to previous view.
Continue to "Select further ap-
plications".
Select the "Horizontal layout"
application.
en
51