Hilti POS 15 Manual De Instrucciones página 54

Showing the recalculated station height after measurement
The recalculated station height is shown after taking the angle and distance measurements and it can then be
confirmed or canceled.
3. Definition of the station height by selecting a point with heights from data memory and measurement of the
vertical angle and distance
The station height is transferred "back" to the station from the height point or height mark, so to speak, by entering
the height point, the tool height and reflector height in conjunction with a vertical angle and distance measurement.
When doing this it is essential that the correct tool height and reflector height are entered.
Corresponding coordinates or positions are searched for in the graphical data saved in the system.
If no point data exists under this name the coordinates have to be entered manually.
Cancel and return to previous
screen.
Measure angle and distance.
Continue, showing the
(re)calculated station height.
Cancel and return to previous
screen.
Setting the station.
Enter height point name.
Cancel and return to previous
screen.
Measure angle and distance.
Continue, showing the
(re)calculated station height.
en
49