Idiomas disponibles
Idiomas disponibles
9.3
CUTTING UNIT - SETTING HEIGHT OF CUT _______________________________
First set the rear roll parallel to the bottom blade
(bedknife). Set the minimum-height of cut setting for
the three ranges of height. Adjust the setting with the
three sets of holes in the mounting housing (D) at
positions 'A', 'B' and 'C'.
Setting the minimum height with the mounting
housings (D) in position 'A' allows a parallel-minimum
height in positions 'B' and 'C'. Select the range and set
the correct height of cut when you adjust the front roll
carriage screws (F) and locknut's (J).
TO SET REAR ROLL
Use a new bottom blade (bedknife).
1.
Set the height of cut setting bar (G) shown below:
a.Screw X to 12 mm (0.47") under the head.
b.Screw Y to 6.5 mm (0.255") to screw thread tip.
Note:The difference between screw X and screw Y is
5.5 mm (0.22")
2.
Set the roll carriage mounting housing (D) bolts
into holes 'A'.
3.
Put the setting bar (G) as shown at one end of the
bottom blade with the screw head X over the lip.
The screw thread Y tip must touch against the
base of the blade.
4.
Adjust the roll to the setting bar (G) while the two
locknut's (H) hold the setting bar screws in
contact.
5.
Repeat for other end of bottom blade (bedknife).
TO SET HEIGHT OF CUT
Select the range of height in which the machine will cut. Adjust the front roll only.
1.
Set the height of cut setting bar (G) with the procedure shown below:
a.The screw X is set to the height of cut needed under the head.
b.The screw Y is not used.
2.
At one end of the bottom blade (bedknife) put the setting bar (G) on rear roll. Make sure that the screw
head is over the bottom blade lip.
3.
Adjust the front roll to the setting bar with the two front locknut's (J).
4.
Repeat for the other end of the bottom blade.
ADJUSTMENTS 9
A
B
A
C
B
C
H
D
H
F
Y
Height of Cut
Minimum
Range
Height of Cut
Holes 'A'
12mm / 0.47"
Holes 'B'
19mm / 0.75"
Holes 'C'
27mm / 1.06"
!
CAUTION
The height of cut range for each set of holes is set
from the requirement of the cutting unit to float. An
increase in the maximum height of cut in any of
the ranges can decrease the ability of the cutting
unit to float.
F
J
G
X
Maximum
Height of Cut
19mm / 0.75"
35mm / 1.38"
47mm / 1.85"
en-85
