Weight Transfer; Reset Default Parameters; Change Pin - Jacobsen F305 Manual De Seguridad, Funcionamiento Y Mantenimiento

6.5.8 WEIGHT TRANSFER _________________________________________________

Weight transfer function transfers ground pressure between the cutting
units and the road wheels, giving either optimal ground following of units
or increased traction at the wheels. Weight Transfer can be selected from
the Settings menu (Section.6.5.4), and then Enabled or Disabled within
the Weight transfer menu. Use Button 2 and 3 to navigate the two op-
tions and then Button 4 to select.
Once enabled the weight transfer will be active unless a lift or lower com-
mands is given (Section.6.7). Weight Transfer will automatically be disa-
bled to allow the units to lift and lower. There will be a few seconds delay
before Weight Transfer automatically re-engages after the lift or lower
command is given which varies depending on which unit is raised or low-
ered.
The weight Transfer icon displays on home screen and shows whether it
is currently active or not. The weight transfer pressure can be adjusted as
instructed in Section 9.2.

6.5.9 RESET DEFAULT PARAMETERS _______________________________________

The machine will have factory set
defaults. You can reset to factory
settings by Using the PIN Menu
Buttons 2 and 3 to arrow up and
down, and Button 4 to select Set
Default Parameters. Press arrow to
confirm.

6.5.10 CHANGE PIN _______________________________________________________

Using the PIN Menu Buttons 2 and 3 to arrow down to the bottom of the
list, and Button 4 to select Change Pin, this gives you the option to
change from the default Owner's PIN Number.
Set Default Parameters
Press To Confirm Set
To Default Parameter Values
CONTROLS 6
Weight Transfer
Disabled
Enabled
Disengaged / Not Active Engaged & Active
Set Default Parameters
Press To Confirm Set
To Default Parameter Values
Are You Sure?
Yes No
Change Pin - Owner
New PIN: * * * *
Confirm: 1 _ _ _
en-41