Idiomas disponibles
Idiomas disponibles
Before measurement, read Notes for Accurate Measurement on the next page.
Normal Measurement
1.
Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2.
Press the
All of the display segments are displayed.
Zero is displayed blinking briefly. Then the
display changes, as indicated in the figure
at the right, as the measurement begins.
The cuff starts to inflate. It is normal for the
cuff to feel very tight. A pressure bar
indicator is displayed, as in the figure at the
right, during inflation.
Note: If you wish to stop inflation at any
time, press the
3.
When inflation is complete, deflation starts
automatically and the
blinks, indicating that the measurement is in
progress. Once the pulse is detected, the
mark blinks with each pulse beat.
Note: If an appropriate pressure is not
obtained, the device starts to inflate
again automatically.
4.
When the measurement is complete, the
systolic and diastolic pressure readings and
pulse rate are displayed. The cuff exhausts
the remaining air and deflates completely.
5.
Press the
the power.
Note: Model UA-656BLE is provided with an
automatic power shut-off function.
Allow at least three minutes between
measurements on the same person.
Measurements
button.
button again.
(heart mark)
button again to turn off
English 15
At heart level
Press
All of the display
segments
Zero display
Starts inflation
Pressurizing
Measurement
in progress
Systolic pressure
Diastolic pressure
Pulse rate
Exhausts remaining
air automatically
